FRANK RUSTECH WD 1950

INTRODUCTION :
Frank Rust Tech WD 1950 is a low volatile solvent based dewatering ( water displacing) fluid and can be applied to water wet metal surfaces to displace water. It ensures a quick and thorough dewatering while leaving behind a light oily film. The product is to be applied by immersion.

BENEFITS : Being a low volatile product compared to conventional dewatering fluids, evaporation losses are very minimal leading to reduced consumption and savings in cost

APPLICATION :
Frank Rust Tech WD 1950 is ideally suited for use on products which had undergone metal treatments like electroplating / anodizing / Phosphating / Chromatizing and etc., It can also be used on components which are to be subsequently treated with a rust preventive that does not have dewatering properties.

Water at the bottom of the tank should be removed as frequent as possible to get best results.

TYPICAL PROPERTIES :

The typical figures for Frank Rust Tech WD 1950 are given in the Characteristics table.

Frank Rust Tech WD 1950 : TYPICAL PROPERTIES

These are typical figures and do not constitute a specification.